Could not access Internet from PC after flashing

Discussion in 'HyperWRT Firmware' started by yci-01, Dec 4, 2004.

  1. yci-01

    yci-01 Guest

    Just upgraded my WRT54GS with 2b3 firmware (from Satori 2.07.1) and after the flash could not access the internet from PC. Router is connected through PPPOE to ISP (Status is connected) and I can tracert from it. However, I could not get my PCs to connect to Internet. My network has a Small Business Server 2003 and couple computers with XP Professional SP1 & SP2.
    I power cycled the router and rebooted the machines. ISP is mindspring (earthlink) using a Netopia DSL modem.
    I have seem some comments on restoring defaults; some say it is not needed. I did not try that yet.

  2. LinkChugh

    LinkChugh Guest

    try the mac clooning on the router

    there is an mac-address clone .. try that
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice