Detecting printer, need special setting?

Discussion in 'Cisco/Linksys Wireless Routers' started by penguin_2000, Sep 6, 2005.

  1. penguin_2000

    penguin_2000 Network Guru Member

    I have a HP printer with printer server connected to the router, but other computers hooked to the hub (wireless or wired) can't detect it when I try to install the printer. Is there something preventing my computers from seeing the printer on the router?
  2. matthiaz

    matthiaz Network Guru Member

    You need to set the right IP address. And what firmware are you running on your WRT?
  3. howardp6

    howardp6 Network Guru Member

    Are you using a print server or are you sharing the printer as a network printer. If you are using a print server, which print server is it?
  4. penguin_2000

    penguin_2000 Network Guru Member

    My firmware is 2.02.7.

    I turned on NWLink IPX/SPX/NetBios protocol and it allowed a wired computer to detect and install. However, when I did the same for a wireless, it was able to detect but NOT install. The error was something like wrong protocol (?!?). Grr... Seems to not want to install via TCP/IP alone; requires the other protocol.

    I'm not sure exactly what the print server is, but it is the one that comes with the HP 2200dn (which is my printer).
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice