Device List? Does it work?

Discussion in 'Tomato Firmware' started by dart451, Jan 17, 2011.

  1. dart451

    dart451 Addicted to LI Member

    Just installed Tomato 1.28 and I've been playing with it a little to get used to it. In the Device List, I've noticed that the refresh button doesn't seem to work. I press Refresh (set at 3 seconds) and the little circle keeps going round and round and doesn't stop. I can connect with a wireless device (kindle) and it picks it's mac address up but never releases it when I turn off the Kindle's wireless. Am I doing something wrong here?
    Also...I also know that Br0 is Wired Ethernet, eth1 is Active Wireless and Vlan is the modem. When I connect the Kindle to my Access Point's (WAP54G) wireless signal, which is connected to #2 Ethernet, it says it's connected to br0, wired ethernet. Is this because it's coming from Ethernet #2 even though it's wireless? Thanks.
  2. rhester72

    rhester72 Network Guru Member

    The MAC will continue to appear in the list until the DHCP lease expires.

    br0 is not wired - it is the bridge connecting wired and wireless.

  3. dart451

    dart451 Addicted to LI Member

    Thanks Rodney! That's kinda what I thought...I found the abbreviations in the Tomato manual that said what they meant.
  4. mstombs

    mstombs Network Guru Member

    The device list also uses the "arp table" to know what devices have connected recently, this table remembers a MAC address/IP address pair for about 5 minutes after device disconnection.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice