DHCP wan (client) vendor class

Discussion in 'Tomato Firmware' started by Mastah, Jun 21, 2013.

  1. Mastah

    Mastah Reformed Router Member

    Hi there!
    I've been looking around but without success.
    Is there a way to tell to the dhcp client (on wan interface) to send a custom vendor class identifier ?

    So far I've seen stuff like
    Advanced > DHCP/DNS > DHCP Client (WAN) => dhcp-option=vendor:mycustomclassvendor

  2. Mastah

    Mastah Reformed Router Member

    Just so you know I'm on a Toastman version (Tomato Firmware v1.28.0502 MIPSR2Toastman-RT-N K26 USB VLAN-VPN-NOCAT)
  3. Mastah

    Mastah Reformed Router Member

    Where (and what name) is the file using to configure udhcp (wan dhcp client) on tomato build ?
  4. Kevin Darbyshire-Bryant

    Kevin Darbyshire-Bryant Networkin' Nut Member

    No config file, all done on command line. Take a look at http://wiki.ph-mb.com/wiki/MER This discusses sending option 61, I think vendor class is option 60 but you can use the same principle.
  5. Mastah

    Mastah Reformed Router Member

    I think (but I might be wrong) that you just need to put "--vendorclass=yourvendorhere" in advanced > DHCP/DNS > DHCP Client (wan) > DHCPC Options.
    Might be "--vendorclass yourvendorhere", I'm not sure yet.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice