Different starting IP address range?

Discussion in 'Cisco/Linksys Wireless Routers' started by martin_nv, Apr 24, 2004.

  1. martin_nv

    martin_nv Network Guru Member

    Hi there,
    I'm wondering if there is a way to have the WRT54G start with a different starting IP address range? I would like to use 10.10.10.x for my network instead of 192.168.1.x. The "Basic setup" page in the router config seems to have 192.168.1.x hardcoded. I'm currently on firmware v2.00.8
  2. Smoky

    Smoky Network Guru Member

    dont think you can do that i think the only thing you can change is the subnet mask
  3. martin_nv

    martin_nv Network Guru Member

    I ended up changing the "local IP address" setting to, then after rebooting/reconnecting the "starting IP address" field had 10.10.10.x there instead of 192.168.1.x. It seems to work fine now. I also upgraded the firmware to v2.02.7 so this might have done it as well.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice