Flashing of HyperWRT failed!

Discussion in 'HyperWRT Firmware' started by Smart71, Sep 5, 2004.

  1. Smart71

    Smart71 Network Guru Member

    I tried to flash the HyperWRT over the Satory firmware. After 2 min. a dialog box told me that falshing failed!

    And now my router (WERT54GS) is DEAD!!!

    Only the Power LED is flashing! Any chance to get my router back to work?

  2. dellsweig

    dellsweig Network Guru Member

  3. Avenger20

    Avenger20 Network Guru Member

    The wrt54g(s) routers are difficult to kill :wink: There is a nice recovery guide on my site (see link above). Instead of 2.02.7 firmware for wrt54g you ofcourse have to use 2.07 firmware for wrt54gs. You should be able to load new firmware on boot-time.

    When upgrading from Satori it's best to disable all services first (telnet/ssh/vpn/...) and do a reboot. This way flashing will have less chance to fail.
  4. Smart71

    Smart71 Network Guru Member

    works again...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice