getting the WAP54G setup right and running

Discussion in 'Other Linksys Equipment' started by calimove, Oct 10, 2007.

  1. calimove

    calimove LI Guru Member

    I have been reading a crap load and I am at a standstill not know what to do next. This is my setup

    WAP54g showed up with 2.06. I loaded 2.07 then loaded up the 2.07 mustdie firmware. confirmed it is there.

    I have the 24db Grid antenna hooked up to the left antenna when the light are facing me. I have the right antenna as the one from linksys. LMR400 18Ft long...

    ethernet cable coming from wap54g to Belkin wireless g plus. It is plugged into one of the four outputs on the belkin...

    belkin set in in wireless bridge mode on channel 11.

    I have no idea what the next step to get it going is...
  2. ericj

    ericj Guest

    It is not likely to work well in diversity mode with 2 different antenna like this, just use the single antenna you want and in advanced wireless settings select left or right (looking from the front). I know from experience that the linksys access point is unlikely to work well (if at all) in client/bridged/repeater mode with other vendors equipment. Use it with another linksys box in this case or use it in standard access point mode.
  3. jimmy870

    jimmy870 LI Guru Member


    I don't understand what you are trying to do. From your text I understand that you have a wap54g with a big antenna which is hooked up to a belkin wireless g using an ethernet cable.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice