Hotel Business and Guest Access

Discussion in 'Sveasoft Firmware' started by roundtrip, Dec 6, 2007.

  1. roundtrip

    roundtrip Guest

    Have the same situation I'm trying to solve using a Linksys SRW208G switch.

    How should I use the VLAN capabilities of this switch to provide isolation between the business systems and guests on the wireless network? Both should have access to the Internet through an attached router.

    e1 = Internet connection to BT Voyager 220V
    e2 = Hard wired connection to business system
    e3 = Hard wired connection to business system
    e4 = WAP (Netgear WG102)

    Still to look at the WAP, but it allegedly supports wireless VLANs. I'd like to allow business and guest access on the wireless network through the use of appropriate VLAN tagging.

    Any thoughts or recommendations?
  2. Disman_ca

    Disman_ca Super Moderator Staff Member Member

    Post move to start new thread
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice