How can i flash over OpenWRT?

Discussion in 'Other Firmware Projects' started by Cooki3s, Jul 24, 2005.

  1. Cooki3s

    Cooki3s Network Guru Member

    Is it possible?
  2. Morpheus

    Morpheus Network Guru Member

  3. bence

    bence Guest

    Tftp didn't work for me.
    Try the following steps:

    1. Enable boot_wait. With boot_wait your router will always use the default IP address and will wait about 3 seconds after power up and *before* boot (a little chance to upload firmware).
    Log in to the router (telnet and type in the following commands:
    nvram set boot_wait=on
    nvram commit
    (thanks to openwrt docs)

    2. Download .exe version of the newest firmware from Run it, and press "Next" twice (welcome screen -> Next -> IP screen -> Next). After two other screens the software will try to upload the firmware. You will see an error message, but DON'T WORRY, don't close the window. Power off the router, wait 4-5 secs, and power on. Right after power on click the Retry button. Voila...

    The original firmware is on your router.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice