How to bridge two wrt54G ?

Discussion in 'Cisco/Linksys Wireless Routers' started by chenmu, Oct 9, 2004.

  1. chenmu

    chenmu Network Guru Member

    Any one can tell me how to setp by setp to setup two wrt54g with bridage .

    Any one know it .
  2. Morpheus

    Morpheus Network Guru Member

  3. chenmu

    chenmu Network Guru Member

    SORRY !

    I said there are two WRT54g used to AP and clinet for repeating area,
    not used to router.

    Any one can help me .
  4. Toxic

    Toxic Administrator Staff Member

    try using satori firmware in both. set one as AP the other as client.
  5. chenmu

    chenmu Network Guru Member

    I had readed more papers and replays .but I can get it .
    My way is :

    DNS(DHCP)--cate5--wrt54g #1( enternet port , wan port not use) ---wireless--wrt54g #2 ( enternet port , wan port not use)---- notebook wireless card

    Setting :

    wrt54g #1 ap wrt54g#2 clinet
    ip ip
    getway getway
    lan mac 00000001 lan mac 00000002

    My problem is notebook wireless card not ping or connect to wrt54g #2,
    but can connect to Wrt54g #1.

    Both Wrt54g can find each RSSI value at there wireless status.

    As I do and test, Alchemy pre v5.3 can get right to WDS ,but Satori 4.0 free failure.

    Other , I try wrt54g #2 at lan port which can not ping to wrt54g #1,but notebook wrieless card can form #2 to #1 and connet to DNS.

    Why #2 lan port can not connet to #1 ?

    Any one can help me!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice