How to read the uptime on Status page

Discussion in 'HyperWRT Firmware' started by jeff1132, Nov 28, 2004.

  1. jeff1132

    jeff1132 Network Guru Member

    Uptime: 1:30pm up 1:10, load average: 0.00, 0.00, 0.00

    what is the syntax here?
  2. dellsweig

    dellsweig Network Guru Member

    UPTIME(1) Linux UserΓÇÖs Manual UPTIME(1)

    uptime - Tell how long the system has been running.

    uptime [-V]

    uptime gives a one line display of the following information. The cur-
    rent time, how long the system has been running, how many users are
    currently logged on, and the system load averages for the past 1, 5,
    and 15 minutes.

    This is the same information contained in the header line displayed by

    /var/run/utmp information about who is currently logged on
    /proc process information

    uptime was written by Larry Greenfield <> and
  3. Avenger20

    Avenger20 Network Guru Member

    Will make it look
    up 1:10, load average: 0.00, 0.00, 0.00
    in next beta. Less confusing :)
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice