howto WEP in client mode ?

Discussion in 'Other Linksys Equipment' started by varun, Feb 12, 2005.

  1. varun

    varun Network Guru Member

    I am using wrt45g as AP.
    I am able to connect WAP54g set as client.

    I want to use 128 WEP.

    I can enable WEP on wrt54g

    I am not able do the same onWAP54G.

    I am not able to save seetings as WEP enabled
    in client mode on WAP54G.

    Only in AP mode I can save WEP enabled in WAP54G. Why ?

    Is there a way out ?


  2. Jogobo

    Jogobo Network Guru Member

    When you are on the "AP Mode" page in the WAP54G and select AP client, did you try to hit the button "Site survey"? Another window should pop up and show the available WLANs within reach. Selecting your WRT should result in another popup window where you can enter the WEP key.

    Just my 2 €-cents.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice