HyperWRT and Boot Wait with 2.1b1

Discussion in 'HyperWRT Firmware' started by gwheaton, Feb 25, 2005.

  1. gwheaton

    gwheaton Network Guru Member

    Ok, I'm New. Just got a WRT54Gv2.2 and installed the 2.1b1 HyperWRT firmware. So far so good. My question. I have read what the "Boot Wait" feature is suppose to do, but how do I turn it on? or is it on by default? I have been thru the settings and can not find anything about "Boot Wait"

    Thanks for the Help
  2. Toxic

    Toxic Administrator Staff Member

    i'm pretty sure boot wait is enabled by default. the description says, ''Boot Wait'' flash protection.
  3. gwheaton

    gwheaton Network Guru Member

    Ok, thanks, I will go by that for now unless someone else says different. I had read somewhere I thought about an older HyperWRT that you had to turn it on, but since I cound not find it anywhere in this verson, I was guessing it was on by default.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice