HyperWRT and Speedboster

Discussion in 'HyperWRT Firmware' started by Judex, Aug 23, 2004.

  1. Judex

    Judex Network Guru Member


    Do you plan to release a firmware for the GS, which supports the speedbooster feature?


    Do you think it would work to boost the transmit power in HyperWRT 1.3 (which works great for me) and flush than back to the original 2.07.2 (german) firmware without resetting to factory defaults? Would the transmit power then stay at 42mW? I'm asking before trying, because entering all the configuration data (MAC adresses etc.) takes some time and the restore feature did not work for me last time I tried it with your firmware (message was: Upgrade didn't succeed).

    Regards, Judex
  2. Avenger20

    Avenger20 Network Guru Member

    HyperWRT 1.4 may have speedbooster support as I'm going to compare the G and GS sources. But can't promise anything yet.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice