Hyperwrt, cable thru vlan1, and client mode cable eth1

Discussion in 'HyperWRT Firmware' started by accord91lx, Apr 3, 2006.

  1. accord91lx

    accord91lx Guest

    Here is the situation. I have a cable modem connected to vlan1 on the wrt54g, and the rest of my lan on vlan0. I put the wrt in client mode to access another access point which is connected to a cable modem. When i put the wrt in client mode it uses eth1 (wireless to other ap) and it cuts out vlan1(my cable modem). I was wondering if there was a way to configure the wrt to use both interfaces simultaniously and load balance between vlan1 and eth1 (wan), while keeping vlan0 as my internal lan. Essentially make the two interfaces (to two seperate cable modems) appear to be one connection to the other computers on my lan. Can this be done?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice