Increase size of JFFS? (For IPT Parse)

Discussion in 'Tomato Firmware' started by victorhooi, Jan 17, 2011.

  1. victorhooi

    victorhooi Addicted to LI Member


    I'm trying to setup IPT Parse on my router (WRT54G v1.1, with Tomato 1.28).

    I've enabled JFFS via the Tomato admin, and it has 700Kb free on a 1Mb partition.

    However, the IPT Parse binary is 895 Kb (version 1.3.3):

    Is there any way to increase the size of the JFFS partition? Or any other way of getting IPT Parse to fit?

  2. rhester72

    rhester72 Network Guru Member

    You can always try compressing it with UPX. There's no way to increase the size of JFFS, it is automatically as big as the room you have left over (the WRT54G has painfully small storage and no expansion potential).

  3. mstombs

    mstombs Network Guru Member

    Didn't know there was a version of ipt-parse that ran on the router - thought it used an offline database. It is a big binary presumably because it includes sqlite3, but the version you link above is higher than that on the 'project' site!
  4. Seeker

    Seeker Addicted to LI Member

    You can always use startup script which wgets it to RAM (/tmp) every startup.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice