IPTABLES question

Discussion in 'DD-WRT Firmware' started by cdaga, Aug 12, 2006.

  1. cdaga

    cdaga Network Guru Member

    Hi All

    How do i use iptables to block traffic between clients connected via the built in switch port of the wrt54g ? (isolate each client)

    also can the same script be used to isolate clients connected via the wireless interface?

    all clients should only be able to send and receive traffic via the wan port.

    I would be using dd-wrt v23


  2. ChemAce

    ChemAce LI Guru Member

    I believe the only option is called AP Isolation, under the wireless / advanced setting, not sure if that applies to the ports, but at least ya could try..

    sorry thats all about I can help right now, When I take a break of work, unfortunately quite awhile form now, Ill do a lil research... if I find anything I reply to this, If I Don't I believe thats all ya can do, from my understandings..

    hope that helps,

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice