it it just me?

Discussion in 'HyperWRT Firmware' started by 3dogs, Nov 22, 2004.

  1. 3dogs

    3dogs Network Guru Member

    I have no problems configuring my unit until I change the Transmit Power from default to any other setting. Once I do that, I can't communicate with the unit until I power cycle twice. Power cycling once does not do it. If I return the Transmit Power to defalt, the problem goes away.
  2. Toxic

    Toxic Administrator Staff Member

    when you flashed to hyperwrt did you do a Hard Reset?
  3. 3dogs

    3dogs Network Guru Member

    I belive I did, but I can try it again. I assume no one else has had this problem but me.
  4. 3dogs

    3dogs Network Guru Member

    I installed the firmware on another unit today. I hard reset for 30 seconds after installing the firmware with the same results (i.e. if I change any setting on the "Advanced Wireless" config page, I can't conact the unit again until I power cycle twice). Any suggestions?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice