linksys e2500 unable to enable vlan tagging

Discussion in 'Tomato Firmware' started by abubin, Jun 3, 2014.

  1. abubin

    abubin Addicted to LI Member

    I just bought a secondhand linksys e2500 v1.

    Immediately I flashed it to latest shibby firmware 119 for e2500. However, I cannot enable vlan tagging for wan. It cannot be checked.

    But I read other people are able to enable tagging. Any idea? Can I enable the tagging using command line?
  2. abubin

    abubin Addicted to LI Member

    nevermind..I found the problem. I had to enable trunk mode in order to be able to enable tagging.
  3. rs232

    rs232 Network Guru Member

    VLAN tagging should work as long as you set the tagged flag next to the port.

    What do you mean by enable Trunk mode? Do you mean VLAN support override?
  4. abubin

    abubin Addicted to LI Member

    Yes, must enable "Trunk VLAN support override (experimental)". Then only I can enable the tagging flag on the port.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice