Linksys E3000 CPU Speed 133 MHz?

Discussion in 'Tomato Firmware' started by srini, Dec 3, 2011.

  1. srini

    srini Networkin' Nut Member

    I am new to tomato and flashed a new Linksys E3000 with this toastman build: tomato-E3000USB-NVRAM60K-1.28.7490.2MIPSR2-Toastman-RT-VPN.bin

    Currently, system Overview shows the following information:

    Model Linksys E3000
    Chipset Broadcom BCM4716 chip rev 1 pkg 10
    CPU Freq 133MHz
    Flash RAM Size 8MB

    I have a feeling this box is running at a lower incorrect frequency. Am I supposed to change the clock speed elsewhere to a higher value?


    > cat /proc/cpuinfo output below :
    ystem type : Broadcom BCM4716 chip rev 1 pkg 10
    processor : 0
    cpu model : MIPS 74K V4.0
    BogoMIPS : 66.35
    cpu MHz : 133
    wait instruction : no
    microsecond timers : yes
    tlb_entries : 64
    extra interrupt vector : no
    hardware watchpoint : yes
    ASEs implemented : mips16 dsp
    shadow register sets : 1
    VCED exceptions : not available
    VCEI exceptions : not available

    unaligned_instructions : 20
  2. Toastman

    Toastman Super Moderator Staff Member Member

    Advanced/Miscellaneous page. Set to 480,240.

    Some routers reset to some hardware default of 133 when no NVRAM setting is defined. We don't know why but once set in the selection box it will remember the setting.

    7491 is latest build.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice