Linksys WAP54G with RT31P2 using Vonage

Discussion in 'Networking Issues' started by enrybm, Jun 21, 2005.

  1. enrybm

    enrybm Guest

    I installed the Linksys router provided by Vonage - it adopted the IP address My PC's connect fine (they now pick up IP addresses in the 192.168.15.xx range. My Wairless access point (WAP54G) works fine - wireless PC's see it.
    I can no longer access the WAP54G usingthe default IP of I have tried several other IP addresses with no luck. How can I find the ne IP address that was assigned to the WAP54G?
  2. Toxic

    Toxic Administrator Staff Member

    Try putting the WAP54G on the same IP range. is 192.168.15.x

    check out my Vonage review of the RT31P2 and WRT54GS for a look at the setup.
  3. cromrell

    cromrell Network Guru Member

    I think you can connect to a WAP54G using the original installation CDs provided by Linksys. They allow you to connect to the WAP54G via a name convention instead of the static.

    Once you are connected to the WAP54G, then you can change the network address to a static address, and use the http://192.168.15.X to administer it.

    Have you tried accessing the WAP54G using

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice