Linksys wrt54GS question

Discussion in 'DD-WRT Firmware' started by n9lya, Sep 14, 2006.

  1. n9lya

    n9lya LI Guru Member

    Hi I have a WRT54GS V 1.1 and a V 4

    I know this may be silly or obvious.. But what is the secrete to opening these two routers up.. I have some of the small stick on Heat Sinks and a couple FANS I Wish to install....

    I pulled the feet off one of them and saw no screws.. And not sure what to do... I do not want to break them...

  2. Esquire

    Esquire Mesquire Staff Member Member

    With the router facing away from you turn the router upside down (i.e., you are looking at the ports at the back) and push the front legs forwards hard with your thumbs... and SNAP and off the blue front plate comes :biggrin:
  3. swinn

    swinn Network Guru Member

    Some versions had screws under the rubber feet that you would want to remove first or you might have some plastic flying around when you do pop it open :)
  4. n9lya

    n9lya LI Guru Member

    Cool beans.. I verified the underside of the rubber feet and then snapped the blue front right out.. Heat sinks and fans added to both.... SET Pwr to 251mw and cpu overclock to 240MHz on the V1.1 and 250MHz on the V4

    Next I will look at other modifications...

    Have a great day... Thanks for both replies...

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice