Major help WAG54G Stopped working!

Discussion in 'Other Linksys Equipment' started by casiolinksys, Feb 1, 2006.

  1. casiolinksys

    casiolinksys Network Guru Member

    Hi all

    Big problem here as I read this thread and it mirrored my problems. So reading the thread indicated that the user had contacted linksys who advised to upgrade the firmware to the one mentioned.

    I (very stupidly) decided to do the same and now I cannot connect to the webpage settings. I can ping the boxes IP address 192168.1.1 but cannot view its settings!

    Have I done perminate damage or is there a way around this. So far I have tried the reset butto on the back of the unit.

    When I did the firmware upgrade I follow the instructions as show in that thread mentioned above. Interestingly enough was that after I had upgraded it, it came back to the settings page OK with the new firmware version at the top. however as the instructions advised a reset I probably did the wrong thing and went for the factory defaults :cry:

    Oh I will be in my Mums bad books as it is her unit. :sadbye:
  2. casiolinksys

    casiolinksys Network Guru Member

    Thankfully for some reason it has srpung back to life. This occurred after taken the unit back to my house and leaving it off for a while. Very strange :eek:
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice