Model displayed on overview page incorrect...

Discussion in 'Tomato Firmware' started by AtTheAsylum, Sep 5, 2009.

  1. AtTheAsylum

    AtTheAsylum LI Guru Member

    Hi all,

    I'm using Tomato 1.25 standard on a WRT54GL router. On the overview page the model is displayed incorrectly as:

    Model Broadcom 4/0x0467//0x10/0x02758

    Not a major problem in and of itself, but I think this is stopping me from using the Administration -> Buttons settings. I just get the following message:

    "This feature is not supported on this router."

    BTW - I have not yet tried a factory reset and then re-entering my settings. I was hoping not to have to do this :frown:

    Can anyone offer any help on this? I've searched the forum without any luck so far.

    Thanks :)
  2. ntest7

    ntest7 Network Guru Member


    I think a factory reset is definitely in order. and maybe a reflash too.
  3. EntityPacket

    EntityPacket LI Guru Member

    This has happened to me after setting up the VPN server
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice