Multiple WAP54G repeaters

Discussion in 'Networking Issues' started by kevk, Nov 16, 2005.

  1. kevk

    kevk Guest

    A quick question.

    Is it possible to use multiple WAP54Gs set-up in repeater mode to connect to the one WAP54G set-up as an access point? I would like to repeat the AP's signal in two different directions and have found I can only get the 3rd WAP54G to connect to the AP when set-up as an AP Client. The 2nd WAP54G works fine in repeater mode.

    My three WAP54Gs are all running Linksys 2.8 firmware.

    I sent this same message to Linksys support and they said it may work but it might not?!

    Has anyone successfully set-up the above?

  2. jollymahesh

    jollymahesh Network Guru Member

    yes it should work out........
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice