MultiSSID on seperate VLAN

Discussion in 'Tomato Firmware' started by STEVEWEST, Apr 7, 2012.


    STEVEWEST Addicted to LI Member

    I am trying to setup a guest wireless network on a separate vlan.
    I built the vlan with a ip range on
    Built the guest ssid
    tied the virtual wireless to br1.
    I can connect and get an ip address, but can not connect to the internet.
    If I set the virtual wireless to br0 it works fine.
    I know I am missing a step, routing table maybe? But not sure.
    Im am using Shibby's 090 AIO and it works great so far!

    Thanks For any help!

    I found this and got it working!
  2. Badders44

    Badders44 LI Guru Member

    What did you find to get it working? Were you able to isolate it completely from your main network?

    I'm in the process of setting up a similar isolated guest network with the same firmware and any do's and don'ts would be most appreciated.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice