My unslung won't recongize my 2 1TB HDs (while 2.3R73 did)

Discussion in 'Cisco/Linksys Network Storage Devices' started by kwanbis, Oct 15, 2008.

  1. kwanbis

    kwanbis LI Guru Member

    Hi, i just bought an NSLU2 (came with FW 2.3R73)

    I turned it on with my two 1TB HDs, and it all showed OK. Problem was that both where NTFS, so i wasn't able to format to EXT3 (it gives no option but FAT32).

    So i installed last version of unslung, but now both HDs show as Not Installed.

    Any ideas?

    EDIT: Note about the Hard Disks.
    Normally, if not connected to a USB cable, or the computer is not on, the USB hard disk would be "on", but "waiting".

    So, with the original firmware, i would turn on first the hard disks, they would go into "waiting mode", and after some secs of turning on the NSLU2, the HDs would spin up.

    The same happens with the unslung, the difference is that after some secs, the HDs would again go to "waiting mode", as if unslung had turned off USB connectivity.
  2. kwanbis

    kwanbis LI Guru Member

    I'm back at R63.

    Still, it is puzzling why unsluged NSLU2 works different in that regard.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice