My WRT350N problem-client computer can not access internet

Discussion in 'Cisco/Linksys Wireless Routers' started by jinzhanhua, May 22, 2007.

  1. jinzhanhua

    jinzhanhua LI Guru Member

    Use DSL,
    view status of wrt350n, connected.
    use Administration,Diagnostics to ping internet computer, ok.
    but client computer can not access internet include ping & dnslookup.
    Yesterday all client computers can access internet. but after power off and power on router today, all failed.
    flash firmware, restore factory setting, same problem.
    have to change to wrt300n, ok now.
    What happen with wrt350n?
  2. starfox101

    starfox101 LI Guru Member

    I have been having the same problem. I thought it was my Mac PPC. To fix it I have found, hold the reset for 30 sec or more. It will then be factory default. You can then set it up again.

    Hope that will helpl
  3. bchumina

    bchumina LI Guru Member

    I have found this happens with any of the newer firmwares. The only way I found on solving this is following the steps below:

    1) Unplug the router
    2) Remove all cords (any computers connected to router and WAN)
    3) Plug back in router
    4) Wait for router to boot up (Wireless and security lights should come on - granted that they are enabled)
    5) Plug in main computer
    6) Plug in Cable Modem
    7) Power on cable modem

    That worked for me - let me know what you think.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice