NAS200 stops responding to share access

Discussion in 'General Discussion' started by nelkem, Feb 3, 2010.

  1. nelkem

    nelkem Addicted to LI Member

    I have two NAS200's - aside from each using RAID 1 - mirroring - I use VicaVersa to copy from one to the 2nd - was working great until yesterday.

    The 2nd NAS 200 unit (copy recipient) will not allow me to attach a drive to the PUBLIC DISK data. I can ping it and I can admin it via IE (though its VERY slow).

    I was going to try a firmware update perhaps - anyone see this behavior before?

    Both units were DHCP - I went static - but same issue (I was just trying to eliminate any variables).

    I can ping by name or IP - tried Explorer mapping and a NET USE * "\\NAS2\PUBLIC DISK" but neither are working - out of the blue!

    Any suggestions greatly appreciated.
  2. nelkem

    nelkem Addicted to LI Member

    media server

    I turned off the media server option and my nas200 works fine since.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice