Need IP Configurations

Discussion in 'Cisco/Linksys Wireless Routers' started by darthvader83, Jun 23, 2006.

  1. darthvader83

    darthvader83 LI Guru Member


    This topic is kind the next chapter of my problem that I already posted below:

    Now I think the problem results in my IP configurations. Here are all my IP configurations, I simply want someone to verify them and tell me what's wrong.

    Router IP Configuration (WRT54G):


    Ethernet IP Configuration:


    Wireless Card IP Configuration:


    If anyone can help me, I'd be thankful :)
  2. swinn

    swinn Network Guru Member

    I just read your original post as well. Here are some suggestions:

    1. Make sure it is hooked up correctly. Your modem should be plugged into the WAN port on your router and any wired computers should be plugged into the LAN ports 1-4.

    2. If you have to rewrite it to look like the above setup then power cycle your router and your modem.

    3. In your ethernet ip configuration above, I see one problem and one potential problem. First you don't have your router's IP address as your gateway ( The other thing is that you have the IP set static within your DHCP range (though this shouldn't cause a problem).

    4. Is your DSL modem in bridge mode? If not (or don't know) then you need to change your Internet type from PPoE to DHCP.

    Let us know what happens..
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice