Network Setup after VPN tunnel working

Discussion in 'Networking Issues' started by i8theburger, Feb 20, 2008.

  1. i8theburger

    i8theburger LI Guru Member

    I am a newbie folks, and I apologize if I was not supposed to start a new thread here. I got my VPN tunnel working between two WRV200s thanks to Toxic.
    Now I just need to find out how to make the two networks see each other. I have the following PC's on one side of the tunnel:
    Win XP Pro
    Win XP home
    Win XP home
    Win XP home

    And at the other end I have:
    Win XP Home
    Win XP Home
    Win Vista Home

    Ideally I would like to set up a raid network drive on one side of the tunnel and restrict folders on is so that only certain people can access certain folders. Is this possible? Any help would be greatly appreciated.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice