New WAP54G official firmware released

Discussion in 'Other Linksys Equipment' started by onesolo, Dec 6, 2005.

  1. onesolo

    onesolo Network Guru Member

  2. Ryckk

    Ryckk Network Guru Member

    big mistake

    The ap was working fine till I flashed the firmware. I did everything according to the instructions. Now I can no longer communicate with it. I've reset to defaults. But no pings, nothing. It's dead.
  3. Ryckk

    Ryckk Network Guru Member


    I was crying prematurely. It was a problem with different sub-domains. I read another post to change my laptop to static address in the proper domain and I was able to communicate and get it working properly, thanks...
  4. mongseng

    mongseng Network Guru Member

    Re: big mistake

    I have the same problem. Any help?
  5. Ande

    Ande Network Guru Member

    Some suggestions:
    - after firmware flash I had to press the reset button for factory reset of the device (press and hold reset button for at least 30 sec)
    - default IP of device after that is
    - AccessPoint with v3 firmware can't be found by the v2 config wizard anymore, so I had to use the AP web interface for initial setup
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice