Newbie Issue with Wireless Bridge Mode - Please Help

Discussion in 'Tomato Firmware' started by bowen873, Dec 2, 2010.

  1. bowen873

    bowen873 Networkin' Nut Member

    Not sure if this is the right place to post this - I just joined the site. I updated my WRT54GL to 1.28 last night. I have it set up as a wireless bridge so that my Cisco VOIP office phone can connect without a hard wire to my network. The phone stays connected, but after a few minutes of talking the calls always get too choppy to hear. It seems like there is not enough bandwidth coming through the router to support the phone calls. Any settings changes I can look at or other suggestions?
  2. bowen873

    bowen873 Networkin' Nut Member

    I've checked everything and I'm still having the issue. The bridge is getting strong WiFi. I'm at a loss. Anyone??
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice