Newbie to WRT54 and setups

Discussion in 'Networking Issues' started by genner, Dec 13, 2005.

  1. genner

    genner Network Guru Member

    Hello everyone,

    I'm extremely new to the wireless scene. I just recently purchased the WRT54gs. My setup is basically this:

    modem goes into a linksys 4port wired router, then port 1 of the router goes into the WAN of the WRT54GS(it's also set as router mode). As I understand it this is my AP. Now I only have two computers I use with wireless. I only want those two PCs to have wireless access through my WRT54GS only. I also don't want to broadcast my SSID, but still able to have the two pcs to get on the internet wirelessly.

    Can that be done? If so How? Ive been messing with the AP a bit and I've gotten to the point where both devices keep on saying aquiring IP address but nothing happens.
  2. dgerard

    dgerard Network Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice