"No Memory" error when trying to flash, erase all won't work!!

Discussion in 'Cisco/Linksys Network Storage Devices' started by mistafro, Aug 29, 2006.

  1. mistafro

    mistafro LI Guru Member

    Hi, I am trying to flash with Unslug 6.8 but keep getting this "No memory" error, I have read that you need to use the erase all utility to get it to work but when I try to load erase all I get a windows error. it's a windows that says 16 bit windows subsystem, the config.nt is not suitable for running ms-dos and windows applications. choose close to terminate.

    What else can I do? I have removed the hard drive on boot.

    Funny thing is, I got this error before when trying to upgrade an official linksys firmware but somehow I got it to work and I didn't use eraseall.

    Anything else I can do?

    Also, does Unslug 6.8 offer performance improvements over the linksys firmware?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice