NSLU2 + WET54G = very slow data rate

Discussion in 'Cisco/Linksys Network Storage Devices' started by eybert, Feb 24, 2005.

  1. eybert

    eybert Guest

    I've connected a 250GB USB2 HD to my NSLU2, and then the NSLU2 to a WET54G. My access point is an AirPort Express. All units connects using 802.11g, and I've enabled WPA.

    The problem is that even though my signal strength is very good, the data rate from the HD is no more than 250kB/sec. I understand that the 54Mbps limit of 802.11g limits the data rate, but I still should be able to get better results than this.

    Does anyone know what I can do to improve this?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice