Open URL after WAN connect

Discussion in 'Tomato Firmware' started by jtheile, Nov 8, 2008.

  1. jtheile

    jtheile Addicted to LI Member

    I'm using the latest stable Tomato build. Is it possible to open an URL, after a connection to the WAN was established? There is no need to show the page, it is just to submit two URL parameters.

    Any ideas? Thank you very much.

    Best regards,
  2. hrvy

    hrvy Addicted to LI Member

    Put a script in Wanup script section using wget/wpost?
  3. jtheile

    jtheile Addicted to LI Member

    Well, so far it was clear to me... putting a script there.

    But I do not know, how the script should look like. Any help?

  4. SgtPepperKSU

    SgtPepperKSU Network Guru Member

    wget <url>
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice