Performance problem when TXPWR set above 40 mW

Discussion in 'Other Linksys Equipment' started by ivo_1985, May 27, 2006.

  1. ivo_1985

    ivo_1985 LI Guru Member

    Hello and sorry for my bad English.
    When I set Transmit PWR above 40 mW the network performance drasticly slow down. Especially on 84 mW. I use WAP54g v2 and v1 with original 5V/2,5A adapter and one AT PSU. The problem is with HyperWap and Freya FW. The signal is becoming better and stronger.

    Any ideas ?
    Thank you.
  2. HellMind

    HellMind Network Guru Member

    In some cases more power not necesary is translated to more performance.

    Try setting the power lower than default, and with a better antenna, or amplificator.
  3. ivo_1985

    ivo_1985 LI Guru Member

    Thanx. :thumb:

    I know why. Because signal is too noisly and crooked. Now I'm using HyperWAP 2.08 and on 53 mW I have almost 2 MB/s speed which in my case is realy good.

    Thanx man, again. :)
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice