PLE200 -- How to unbrick?

Discussion in 'Other Linksys Equipment' started by originalsnuffy, Feb 11, 2009.

  1. originalsnuffy

    originalsnuffy Network Guru Member

    I have a PLE200 powerline adaptor. I managed to brick the device with a failed firmware update.

    There is no obvious way to unbrick the device via software or reset.

    Anybody have any tricks or suggestions on what to do? I hate to recycle (disposing) the unit, but this is looking like my best bet.

    Oh yes, the unit is out of warranty and linksys does not seem to care that it bricked using their software update mechanism.
  2. mstombs

    mstombs Network Guru Member

    Any idea what OS or bootloader it uses? I've noticed the sercomm utility used to flash an NSLU2 also notices my PSUS4 and could upgrade it.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice