Please confirm install steps for WAP54G v1.1

Discussion in 'MustDie Firmware' started by CountRugen, Jan 25, 2007.

  1. CountRugen

    CountRugen LI Guru Member

    I apologize if this is a repeat - there is so much information in this forum I'm requiring clarity.

    I own a WAP54G v1.1, running Linksys fw 3.04. I don't want to end up with a brick, because I have many items running on my wireless network that cannot be offline for too long.

    Please confirm/correct my assumptions below. Also please point out any steps I can skip or steps I am missing (or steps that will most definitely brick my AP).

    In order to install MustDie 2.07, I infer that I must:

    1) Find and install the Linksys v 2.07 fw for my model.
    a) This can be found here:
    b) If the AP complains about the downgrade, I change my settings using http://<<ap ip address>>/fw-conf.asp.​

    2) Download MustDie 2.07 trx.

    3) Click the "Reset" button on the AP to clear some memory

    4) Install the MustDie fw using the upgrade utility in the AP (using a computer wired to the LAN)

    5) Perform a HARD RESET of the AP.

    6) Since my home network is not in the class, I need to change my wired machine to that class to access the AP to change its config.

    7) I change the config of the AP back to my IP class. Change other settings as necessary.

    8) Change my wired machine's IP back and I'm good to go.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice