please help!!!! Need to recover my wrt54g

Discussion in 'Sveasoft Firmware' started by JayLasad, Mar 13, 2005.

  1. JayLasad

    JayLasad Network Guru Member

    I installed the sveasoft firmware and it finished successfuly, however after i rebooted my wrt54g, the power light is continuously blinkling. I cannot revert to another firmware because i cannot see the IP nor ping it. It is acting as if it is a hub so i cannot use explorer to access it and i dont how to fix this. I would appreciate any help on how to load another firmware and make it work again. I am curretnly using an older dlink router and i am running out of idea on how to fix this problem.
  2. Toxic

    Toxic Administrator Staff Member

    WHat version of WRT is it?

    1.0 1.1 2.0 2.2 ?
  3. JayLasad

    JayLasad Network Guru Member

    I have v2.0 of the wrt54g
  4. t4thfavor

    t4thfavor Network Guru Member

    hold in the reset button for a looooong time.

    then before you boot the wrt, do a ping -t to the default ip of the router which is i think
    plug in the router and it should start responding to pings.
    then you can tftp the new firmware to it.

    if that doesnt work you have to do a scary operation which involves you using the search button on the forum to find a guys post in which he dissects the router and shorts pins out to un-brich the router
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice