Port forwarding for dual wan failover Fresh Tomato

Discussion in 'Tomato Firmware' started by Timothy L, May 17, 2019 at 4:47 AM.

  1. Timothy L

    Timothy L New Member Member

    Was wondering if it was possible to get remote access to camera ports on outside of network after failover.
    I have a cisco e4200 router with fresh tomato firmware installed. In a non failover mode, there is access to ports but in failover there is not. Is it possible to bridge the ports to the second wan? There is remote access to the gui in failover but no camera access remotely. Thank you for any help.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice