Port Forwarding

Discussion in 'Tomato Firmware' started by blazevski, Dec 27, 2010.

  1. blazevski

    blazevski Networkin' Nut Member

    Hello to everybody,

    First, sorry for my bad English.

    Now the problem. I recently bought a Dreambox 500S, and for card sharing, i need to open a port on my router. I have a Linksys WRT54GL with Tomato firmware. I opened a port in Port Forwarding tab, set the IP address from the Dreambox, set the port that i like to open, and everything is fine. But the problem is that i am connected on the Internet through WiMax antenna/modem. When i check if my port is open, the results are bad, my port is not open. What i find out, is that when i type my IP address in a browser, i am getting the Login page for my antenna, and i don't have the Username and Password. In the Overview tab, i can see that my router is getting an ip address from the modem/antenna etc. 192.168.254.X .

    I think that's the problem, i successfully open a port in my router, but from the outside you just see the ports that are open in the modem, not on my router.

    Can you please help me, how to make this work, i also work with WAMP and i need to set Virtual Hosts, but i can't.

  2. TT76

    TT76 Networkin' Nut Member

    can you post the ip address of the wan and lan interface of your modem and router?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice