Discussion in 'Tomato Firmware' started by masterbeto, Oct 24, 2006.

  1. masterbeto

    masterbeto Network Guru Member

    any know any bug in tomato firmware about portforward ?
    i try forward my xxx.dyndns.org:8082, in first ap i put in forward 8082-8082 to but it no work, any know if are any bug or my config is error?
  2. fareal

    fareal LI Guru Member

    are you trying to forward from external port 8082 to internal port 8082 to ip
  3. masterbeto

    masterbeto Network Guru Member

  4. fareal

    fareal LI Guru Member

    try leaving the "Int Port" field empty
  5. canis

    canis Network Guru Member

    May be you should enable loopback interface for testing. Otherwise you could get strange results if a store-and-forward switch is physically between the units?
  6. NateHoy

    NateHoy Network Guru Member

    I don't think it makes any difference, but normally you would note a single port as just the number, not a range. So try forwarding port 8082, not 8082-8082.

    Also there is the checkbox to activate the port forwarding. Make sure that is checked, and also make sure the word "On" appears to the left of the port forwarding entry when the entry is set. That will indicate that the port forwarding is actually active.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice