Possible Bug?

Discussion in 'Tomato Firmware' started by nu2u, Mar 31, 2007.

  1. nu2u

    nu2u Network Guru Member

    After observing the bandwidth monitor in tomato 1.06 on my linksys wrt54gs v3, I get the following read outs during data transfers;

    Internet traffic xfer to wired node = WAN + eth0 + vLAN1 (show activity on the graph)

    Wireless LAN xfer to wired node = WL(eth1) + eth0 + vLAN0 (show activity on the graph)

    Wired node xfer to wired node = nothing (no traffic on any interfaces in tomato)

    Is this normal?
  2. der_Kief

    der_Kief Super Moderator Staff Member Member


    please post some screenshots ! So its easier for the people to analyze this.

  3. nu2u

    nu2u Network Guru Member

    Ok the 3 pics are as follows;

    tomato_wlan - i have a transfer going from a wireless device to a wired device and see the same bandwidth utilization under WL(eth1) + eth0 +vLAN0

    tomato_wan - i have a transfer from the web and see the utilization under = WAN + eth0 + vLAN1

    tomato_lan - i have a transfer going from 1 wired device to the next (no graph anywhere)

    Hope that helps

    image order is

    _lan, _wan, _wlan

    Attached Files:

  4. nu2u

    nu2u Network Guru Member

    So can anyone tell me if this is normal (based on the graphs in your router while doing LAN transfers)?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice