Possible to run WRT54G in both client and repeater modes.

Discussion in 'Cisco/Linksys Wireless Routers' started by eno45, Apr 6, 2005.

  1. eno45

    eno45 Network Guru Member

    I have setup a WAP54G as repeater in the past. I noticed it would repeat the signal and at the same time I could plug in my laptop hardwired and get a internet connection just hardwired with my WIFI disabled.

    Now I want to do the same thing with a WRT54G. I would like it to be able to output internet through all 4 ports plus repeat the signal. Is that possible?

    My hardware is :
    Linksys WRT54G v2 (Firmware_Alchemy-6.0rc5a) [main router]
    Linksys WRT54G v2 (Firmware_Alchemy-6.0rc5a) [repeater]

    I have been searching the site but with all the possiblities I am not sure which layout or guide would allow this to work. If you could, just say what I am trying to do in the correct termology so I can relate easier on what I am trying to do.
  2. karamba

    karamba Guest

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice