Problem with bootload of RV042

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by TheSurf, Apr 18, 2005.

  1. TheSurf

    TheSurf Network Guru Member

    Hi @all,

    mybe you can help. The Linksys Support is only a pice of crap.
    They don't flash your router back, they say it is broken and over.

    Back to my case:

    I have flashed a 1.3.3 and swithed the rv042 off für about 2 weeks.
    When I switched it on I only got a Diag-Led flasching.
    Then I start examine and found the bootloader. With the help of this thread I managed to get an other firmware running. I can boot it with "boot -s 2". But when I switch the router off, it always goes back to bootloader and I habe to put in "boot -s 2".

    Can someone send me his config-output from:

    bset and vom "rg_config_print /bootloader"??

    Hope to hear from you, you are my last hope!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice