problem with new wrt54g and satori firmware

Discussion in 'Sveasoft Firmware' started by cm45, May 22, 2005.

  1. cm45

    cm45 Network Guru Member

    i just got a wrt54g, and changed the firmware to the satori. once it was done i pressed ok after it said the upgrade was successful, but after that i could not connect to the internet or log on to the router. with the router connected. what can i do to go back to the original settings or get the satori firmware to work. i already tried pressing the reset button for 10-30 seconds and that did not work.
  2. Couledouce

    Couledouce Network Guru Member

  3. 36080

    36080 Guest


    I think Satori only supports WRT <= v2.0. I sadly did read the readme file after I flashed it.

    I upgraded mine to Satori, and did not get any response at all using www or telnet. The "good" thing is that when flashing to a new firmware it resets, and you have an access point with SSID = linksys. I manged to hock up using wireless and did a new flash using a firmware supporting the v.2.2 which I have. It's not recomended flashing using wifi, but I guess it is worth the risk :)

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice