Problems to enable ports

Discussion in 'HyperWRT Firmware' started by x-ecuter, Nov 30, 2004.

  1. x-ecuter

    x-ecuter Network Guru Member


    I upgraded the firmware for the last HyperWRT avaiable, before I used the version 2.04.4 from Linksys, since the upgrade i'm not able to connect on e-mule with hi-id.
    With the firmware of the linksys it was enough to configure the doors for everything works fine, with HyperWRT I didn't get.

    Any help is welcome.
  2. hotfix

    hotfix Network Guru Member

    Use static IP (e.g. no DHCP) and forward eMule ports 4662 TCP and 4672 UDP to your PC running eMule.
    I have no problems at all. :D
    For security reasons don't use UPnP. (Just my 2 ct.)
  3. x-ecuter

    x-ecuter Network Guru Member

    Thanks, but it's just how i'm using here.
    My PC is with static IP, the Linksys UPnP is disabled and both TCP and UDP ports are forwarded to my PC's IP.
    If i downgrade to 2.04.4 it works fine, i tried the HypertWRT 1.3 and it works fine too.. the problem is only if i use the Linksys 3.01.3 or the HyperWRT 2.0
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice