Problems with accessing my WAP11

Discussion in 'Other Linksys Equipment' started by erikjanR, Aug 24, 2006.

  1. erikjanR

    erikjanR LI Guru Member


    I have a (even more) WAP11 v2.2 which we are using with externall antenna's to have a real WAN. Working fine for a few years, until.....:frown:

    My WAP11 is not accessable anymore over the wired ethernet. When the power is connected onle the power led is on (Although, looks he is not working on full power). The Wifi and the lan activityleds remain dark. No access is possible. Even a reset has no impact.
    I have checked the power and that is stable at 5v DC

    Does somebody has any idea for me to look to?:thumbup:

  2. jgutz20

    jgutz20 Network Guru Member

    power surge/dip? did you reset to factory defaults and re-configure
  3. erikjanR

    erikjanR LI Guru Member

    I have reseted as good is I know (holding on the reset butten while inserting the power connector etc). Because there is NO communications to my ETHERNET connection I'm not able to reconfigure the device.
    If there are other ways to give a better reset and to reconfigure etc I'm open to try so.

  4. rdgraphics

    rdgraphics Guest

    I got the same problem !!! some one know how to solve it ??
  5. I got the same problem :( some one know how to solve it too??
  6. menot23

    menot23 LI Guru Registered

    I got the same problem.

    Please somebody help.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice